zest-it ® logo

Zest-it®Glue Dot Remover

zest-it ® logo

HOME ZEST-IT PRODUCTS STOCKIST MEDIA COLOUR TOOLS HOW TO

About Zest-it® Glue Dot Remover

Glue Dots are so effective for all sorts of jobs but difficult to remove when no longer needed.

50ml Zest-it Glue Dot Remover

50 ml Zest-it® Glue Dot Remover

glue dot and brush

Old glue dot being removed from a surface

Glue Dots are so useful especially to Decoupage, Carders and Craft artists, there-again, like all good adhesive, can be difficult to remove.
Zest-it Glue Dot Remover will do the job cleanly and efficiently, it is non-flammable, non-toxic and almost pH neutral, works for glue dots, micro dots, sticky pads, sticky labels, foam pads, velcro type tape and pads, and leaves no residue of itself in the paper.

To remove the glue dot - take a soft brush or cotton bud, apply Glue Dot Remover to the surface and around the dot.
It also helps to prick the surface of the glue dot with a pin, this allows the remover to penetrate the dot more thoroughly and speeds removal.
Allow the remover to dwell on the dot for 1 to 2 minutes, Zest-it is not an aggressive solvent so patience is always rewarded.

Use a spatulas, palette knife or similar to ease around the edges of the dot allowing the fluid to seep under the dot. Use the wet brush or cotton bud to apply a little more, tweezers are useful at this point, hold the dot with the tweezer and slide the brush between the dot and the surface, watch carefully as the Zest-it Glue Dot Remover does its work. Ease the dot from the surface and discard.

If sticky residue remains, wet it again with the brush or bud and then use the brush to collect the sticky stuff that remains.

Allow to dry thoroughly, if paper 24 to 36 hours; if a non-pourous surface then wipe clean and dry with a soft cloth, leave for 10 minutes to make sure the Zest-it Glue Dot Remover has thoroughly evaporate from the surface.

Because it evaporates completley it leaves no residue in the paper and does not stain - any staining will be from the dissolved dirt removed at the same time as the glue dot. If the paper has become 'transparent' from the tape/dot it will need soaking to remove the residue - unfortunatley the Glue Dot remover will not repair damage to the paper!

Copyright© Jacqui Blackman 2008

Sizes available - 50 ml only.

 


Back to the Products page


ZEST-IT OIL PAINT COLOUR TOOLS HOW TO LINKS
Products How Paint is made Colour Mixing Brushes Techniques Art Links
Stockist - UK Using Oils Colour Pigments Easels Pencil Blending Remarks
Stockist - Worldwide Oil Pastels Colour Wheel Palettes Brush Strokes FAQ
About MSDS Oil Bars Tonal Values Knives Tuition Links Search
Testimonials Fat over Lean Warm and Cool Surfaces Inking Contact
Video Wet on wet     Tole Privacy
    HOME      


Copyright 1999 - 2016 © J. & T. Blackman Ltd. All Rights Reserved.
The information contained herein is the Intellectual Property of Jacqui Blackman and
J. & T. Blackman Ltd., and is supplied without liability for errors or omissions.
No part may be reproduced or used except as authorized by contract or other written permission, unless stated otherwise. The copyright and the foregoing restriction on reproduction and use extend to all media in which the information may be embodied.

Zest-it ® and the Logo are a Registered Trademark.